Fix It Sticks Scope Jack

A new way to level your optic, the Fix It Sticks Scope jack works with any 1/4 inch driver to quickly and easily level your scope to your rail.

This design differs from some other scope leveling devices, as it does not mar the bottom of your turret. Some other devices need to be wedged in from the side which can leave marks sometimes.

To use, just mount the scope jack to the pic rail under your scope and turn the drive handle until the lifting arm engages with the flat section under your turrets. Once the scope is level, maintain pressure while tightening your ring screws to keep optic level throughout the process.

Requirements:

Works with any scope with a flat section under turrets
Needs a minimum of 1/4 inch clearance between rail and scope
Pic rail must be accessible under optic
In cases of minimal clearance, it may be necessary to remove the thumb screw and clamp, then slide the Scope Jack onto the rail from the side and reassemble.

Integrates perfectly with Fix It Sticks Replaceable Edition and T-Way Driver.

SCOPES & SPOTTERS / level